This is not the topic of this thread however so I will not get into that here. Re: Need help setting up Simplify 3D with Robo R1 Plus model Thu 11:25 am Well, I would start with the Robo3D R1 settings that they already have in the configuration assistant. The odd thing is that it does not appear in the precompiled beta bin. I have also found Rep firmware has a bug that shows it's ugly head a few days after you install it and I believe it is related to the communication setup as well. I have not figured out how to prevent this firmware from doing this yet and to only send the ACK that most host expect. In Machine settings we have to indicate if we are using a Cartesian machine or a delta. When you talk about printing speed (on Facebook or with friends) normally start of mm/s, and set it on the software will help you to avoid confusion. It constantly sends and OK or actually whatever you want to put on that line which cause other host to error out as they are expecting an OK or READY only once and nothing else. In the Preferences Tab I recommend that you set mm/s instead of the default mm/min. But unfortunately as I have found the Repetier firmware seems to only want to play with the Repetier host. mainly because you could then fine tune feed rates and esteps per access to get precise dimensions and flow. In fact if you could flash the firmware and then use S3D I bet it would even out shine those still using it + stock firmware. Carl, in your experience (not considering the price difference) do you think the Simplify 3D software would give as good or better end results than flashing the firmware and using Repetier software?Īs I said I have not used it, but from what I have seen of the videos and specs I would have to say yes it would simply based on the fact it has much more flexibility.

Simplify 3d help